“program wrong!”

No, the program isn’t wrong.

You put the wrong part up there. You put a 36 inch long part and selected a 33 inch program, and you think the program is wrong?


About Bill

The owner and proprietor of this site. Feel free to message and say hello
This entry was posted in Work. Bookmark the permalink.

3 Responses to “program wrong!”

  1. Naeem Chaudhry says:

    “On two occasions I have been asked, “Pray, Mr. Babbage, if you put into the machine wrong figures, will the right answers come out?” I am not able rightly to apprehend the kind of confusion of ideas that could provoke such a question.” – Charles Babbage

  2. Bill says:

    Well, the program ran correctly. It’s just when you put the wrong size material underneath the router, it cuts what it thinks is the material you placed there, not what you actually did.

    it’s not that smart….. but smart enough.

  3. Andy says:

    Sigh, I know this story all too well…

Comments are closed.